 |
> PLC AUTOMATION SYSTEM> Power Supply,Thumbwheel Modules, Special Modules |
 |
|
 |
| Spec. / Model |
FBs-4PT |
FBs-ATC2 |
FBs-1LC |
FBs-AXC2 |
| Features |
4 channels, 16-bit potential
meter input module
(Impedance range: 1K~10K Ω) |
2 channels, auto. tuning
temperature control module
with 0.1°C resolution |
1 channel, load cell module
with 20-bit resolution |
2 axes, with linear uncircular
interpolation motion control
module |
| Wiring mechanism |
7.62 mm terminal block |
| Dimension |
Figure 4 |
|
|
|
|
| ^ TOP |
 |
Power Supplies for Expansion Modules |
|
|
|
 |
| Spec. / Model |
FBs-EPOW |
FBs-EPOW-D |
Capacity of output
power |
24VDC Bus power |
400mA
|
400mA |
| 24VDC
Bus power |
250mA |
165mA |
| Sensor power |
250mA |
165mA |
| Max. power consumption |
100 ~ 240VAC
-15%/+10%, 21W |
15VDC/24VDC
-15%/+20%, 15W |
| Wiring mechanism |
Wiring mechanism 7.62 mm terminal block |
| Dimension |
Figure 4 |
|
|
| ^ TOP |
|
Thumbwheel Switch Input Module |
|
|
|
 |
| Spec. / Model |
FBs-32DGI |
| Refresh time for input |
10mS max. |
| Input capability |
8 words (32 digits/128 individual points) |
| Input method |
1/8 duty multiplexing input scan |
| Wiring mechanism |
30 pins header with latch |
| Dimension |
Figure 6 |
|
|
| ^ TOP |
|
7/16-segment LED display modules |
|
|
|
 |
| Spec. / Model |
FBs-7SG1 |
FBs-7SG2 |
| Display mode |
Decoding display |
4 bits to represent a character.
It can display 16 kinds of pre-decoded character including 0 ~ 9, –, H, E, c, t and all blank |
| Non-decoding display |
Each segment controlled by 1 individual bit |
| Display number of character or points of LED |
8 (4*) characters or 64 points individual LED |
16 (8*) characters or 128 points individual LED |
| Refresh time for display |
10mS max. |
LED driving
specification |
Driving current |
40mA /segment |
| Display method |
1/8 duty multiplexing display |
Driving
voltage |
Low voltage |
5VDC (can be 10% up) |
| High voltage |
7.5V, 10V, 12.5V selectable (can be 10% up) |
| Fine tune of voltage drop |
0.6V, 1.2V, 1.8V selectable |
| Over voltage driving indication |
Each channel has individual Over Voltage (O.V.) driving LED indication |
| Isolation method |
Transformer (power) and photocouple (signal) isolation |
| Power consumption |
24VDC –15%/+20%,static consumption is 2VA max., dynamic current is increased according to display. |
| Wiring mechanism |
16 pins flat cable, 2.54mm header connector |
| Dimension |
Figure 4 |
|
|
| ^ TOP |
